2 SETS! Black Walnut Rails Pioneer RG-2 RG-60 RG-70 RG-9 SR-303 SR-60 SR-70 SR-9

Description

TWO (2) SETS!!! At a discount price!
Black Walnut Side Rails for your Pioneer Signal Processor
Made to exacting standards by hand in the USA using only the highest quality solid Black Walnut.
Give your Classic Pioneer Signal Processor a facelift!
These Solid Black Walnut Side Rails give you Pioneer a splash of class that it deserves.  Nothing looks better than Walnut and Silver.
The rails are held in place with super-strong 3M double-sided tape. Of course the 3M tape is included - and pre-installed for your convenience.
Easy as pie to install.
Peel the red tab protective cover from the 3M tape (tab shown in close-up picture).
Slide the rail over your faceplate - positioning it evenly with the top of the faceplate.
Press firmly so the tape attaches to your unit (it sticks to the side of the case - NOT the silver face).
Enjoy the new look!
As easy to remove too:  Just pull the rails and the tape will release.
Which Pioneer Components will these Side Rails fit?
This rails in this listing fit the following Pioneer Components:
Pioneer RG-2 Dynamic Processor
(shown in the pictures)
Pioneer RG-60
Dynamic Processor
Pioneer RG-70
Dynamic Processor
Pioneer RG-9
Dynamic Processor
Pioneer
SR-303 Reverberation Amplifier
(shown in the pictures)
Pioneer
SR-60 Reverberation Amplifier
Pioneer
SR-70 Reverberation Amplifier
Pioneer
SR-9 Reverberation Amplifier
Please keep in mind that wood varies in appearance.  The item you get may vary slightly than the samples depicted in the ad.
What you will
receive
:
Four (4) side rails (cheeks) made from Black Walnut Hardwood.
3M double-sided tape on both rails (already attached).
The PIONEER Components shown in the Listing Pictures
ARE NOT INCLUDED
!
Check my feedback and bid with
confidence
.