Treble Bleed Mod Duncan style 1000pF/150K 1% Tolerance Sliver Mica Capacitors

Description

This is a
PARALLEL
or
"Seymour Duncan"
type treble bleed circuit.
This listing is for ONE assembled treble bleed mod circuit.
Is the tone on your guitar or bass getting muddy or dark as you roll off the volume? This is an unfortunate side effect of the electrical resistance of potentiometers and pickups. As you roll off the volume, a "low pass filter" is created. The result is that your tone will get inconsistently darker as you lower volume.
A Treble Bleed circuit (or, "high pass filter") will help retain highs as you roll off the volume of your guitar or bass.
You can find my page on FB by searching
" AlexC Guitar Pedal Clones
".
Simple to install - just solder to the lugs of your volume pot(s) as shown in the image. Instructions are also included in the package. This mod takes only a couple of minutes and requires only basic knucklehead soldering skills. The circuit itself is completely assembled/soldered, as shown in the photos. You need only solder the two main leads to your volume pot.
Capacitor:
Expensive Sliver Mica 1000pF  ±1% tolerance
Resistor:
Metal Film 150k Ohm 1/4 Watt  ±1% tolerance